Technical FAQs

Ask a Question

What are the causes of a drive overload which is connected to a motor that runs a screw by gearbox ?

 The problem of over loading observed may be due to any of below reasons:
  1. If it is a screw extruder, there may be extrusion material struck in the screw, which can cause over loading, if so the same to be cleaned before re-starting the screw extruder. 
  2. There is a possibility of jamming or damage of gears or bearing jamming in gear box, which can also cause over loading.
  3. If it is a new drive under installation and you are facing problem, it may be due to inadequate drive rating selection. 
Was this helpful?
What can we do to improve the information ?