Technical FAQs

Ask a Question

What's the difference between an Autoset and manual set in Varlogic NR6/NR12 ?

The auto setup sequence is intended for inexperienced users so that they can commission the bank with minimal prior knowledge. The user needs only to input three of the most common parameters ( CT, voltage and Cos phi ) and then launch an automatic search for the other parameters. The Varlogic checks if the parameters entered are correct and search for other needed parameters in the network.

If there's an error, the error code will be displayed, which enables the user to search for this code in the fault table ( attached ) and perform the action needed to clear such fault.
Was this helpful?
What can we do to improve the information ?